Step 1

Compatibility Quiz

Make sure to take the compatibility quiz before starting.

Step 2

Access the Charging Port

Ensure visibility of the Knob. Use both hands to pull the Knob Top apart from the Knob Bottom in a downward motion.

Step 3

Sticker Placement

Place one sticker on the Knob Top and a matching sticker on the Knob Bottom, using the same color for both.

**Each Smart Knob must have its own unique color. The Knob Top and Knob Bottom with matching stickers must stay together as a pair and cannot be swapped with parts from other Smart Knobs.

Step 4

Charging the Knob

Charge your Knob Top by plugging it into the included charger. The Knob's LED lights should flash blue to indicate it is charging (it will turn solid blue once fully charged).

Step 5

Removing the Old Knob

Remove your original stove knob and any plastic or rubber pieces that can be detached. Do not remove any permanently attached parts.

Step 6

Cleaning the Surface

Wipe down the surface around the stove shaft with the alcohol wipe to clear any grease, dirt, or debris.

Step 7

Off Position Reference

Figure out where the off position is and take note.

Step 8

Placing the Knob Bottom

Place the Knob Bottom on the stove shaft with the gold pins pointing to OFF.

Step 9

Aligning the Shaft

Use the install key to tighten the shaft so it's centered. Twist right to tighten a little bit (do not tighten all the way). You should still be able to remove the Knob Bottom off the shaft easily.

Step 10

Removing Adhesives

Pull the Knob Bottom off, flip it, and remove the adhesives from the rim of the bottom.

Step 11

Setting Off Position

Slide the Knob Bottom back onto the shaft with the gold pins facing the off position. Push down and hold for 15 seconds to secure the reaction plate on the stove surface.

Step 12

Installing Spacer

Insert the install spacer behind the Knob Bottom and against the stove surface. It should fit around the reaction plate.

**For Electric Ranges, use the orange install spacer. For Gas Ranges, use the white install spacer.

Step 13

Tightening the Knob Bottom

Push down on the knob so it is sitting flush against the install spacer. Use the install key to tighten the Knob Bottom completely. Make sure it is secure.

Step 14

Removing the Install Spacer

Remove the install spacer from behind the Knob Bottom.

Step 15

Testing the Knob

Ensure the burner surface is clear of all objects. Push and turn the Knob Bottom to turn the burner on and off.

** If this doesn’t work properly, loosen the shaft and restart the installation process. You can also reach out to customer support for assistance!

Step 16

Final Knob Assembly

Attach the Knob Top to the Knob Bottom, ensuring the pins and notch align at the OFF position.

Step 17

App Calibration

Download the Ome app and start the calibration process. Follow the instructions to calibrate the Smart Knob.